What Command Line Utility can be Used to Repair the Bcd on a Windows Installation??

What Command Line Utility can be Used to Repair the BCD on a Windows?

Type Bootrec /Fixboot at the command prompt . Type Bootrec /rebuildBCD at the command prompt. This means that one of the following is true: The boot configuration database BCD already exists.

What can you Use to Determine Whether the SATA Port No which you are Connecting the Drive will Also Run at 6.0 Gbps?

What can you use to determine whether the SATA port no which you are connecting the drive will also run at 6.0Gbps? Motherboard manual. If you are adding a hard drive to a system that already has a drive with Windows installed on it, what should you do? Boot Windows and use Disk Management to prepare the new drive.

What Type of RAID Volume is Used for Fault Tolerance and only Requires Two Drives?

RAID 1 : RAID 1 is also known as “disk mirroring”. RAID 1 writes two drives at the same time, and each drive is an exact duplicate of the other. If one disk fails, you can restore data from another one. So it provides fault tolerance and it requires two drives for a RAID 1 setup.

What is the Current Maximum Storage Capacity Limit of a Magnetic Tape?

Like the hard disk and the transistor, magnetic tape has advanced enormously over the decades. The first commercial digitaltape storage system, IBMs Model 726, could store about 1.1 megabytes on one reel of tape. Today, a modern tape cartridge can hold 15 terabytes.