How to Take Apart a Ps3 Slim?

PlayStation 3 Super Slim Teardown

The hard drive I removed three rubber feet that run along the back and side of the units bottom and a void if removed warranty sticker. Next I remove the screws that were all underneath.

What Tools do you Need to Take Apart a PS3 Slim?

Tools required: phillips screw driver, exacto razor, T-8 star driver. Gather all neccesary tools and place your Sony PS3 Slim on a clean, flat surface. Use a soft cloth or towel to place under it.

How do you Take Apart a Playstation Slim?

It is easy; just pry up on the two corners of case with your fingers. The next step is to remove the power supply of the PS4 slim. Remove the three screws with a PH0 screwdriver. Next, using T8 Torx screwdriver unscrew three screws and remove the metal panel.

What Screwdriver Do you Need to Open a PS3 Super Slim?

This a security tamper proof T10 screwdriver that will open up Sony Playstation PS3 "Fat" and will assist in the disassembly of an Xbox 360 The screwdriver is a Tamper Proof torx screwdriver which means that it has a hole drilled in the middle of the tip!

How do you Take the Cover off a PS3 Slim?

Turn the PS3 over and lay it on its backside. Carefully peel the warranty sticker up off the lower case to reveal a hidden screw cover. To avoid activating the VOID that may come up, heat the sticker carefully to remove and replace it cleanly.

What Screwdriver Do you Need to Open a PS3 Slim?

Tools required: phillips screw driver, exacto razor, T-8 star driver. Gather all neccesary tools and place your Sony PS3 Slim on a clean, flat surface.

What Tool do you Need to Open a PS3?

Phillips #1 Screwdriver.
Spudger.
T8 Torx Security Bit Screwdriver. $5.99.

How To: Disassemble PS3 Slim Full HD

And to remove the hard drive you just flip up this tab. And there's a blue screw you unscrew flip it to the front.

What is the Blue Screw on the Bottom of my PS3?

Remove the three (or on some models, four) T8 security Torx screws on the underside of the PS3 slim. Security screws? Yes, that's right. These screws have a pin in the center of them that prevents an ordinary Torx screwdriver from working.

How do I Open the Top of my PS3?

Lift the top cover from its rear edge and rotate it toward the front of the PS3. Remove the top cover. There is a plastic hook located in a hole on the top back right hand side corner. Carefully push the plastic hook a bit front the rear of the machine with a spudger to release the rear right of the casing.

What Screwdriver Do you Need to Open a PS3 Slim?

Product Description. Item Descriptions: - T8 Security Torx set - Xbox 360 console, XBox 360 controller, PS3 slim and fat, PS4 (uses a T9, however T8 fits fine), cant open PS4 controllers will need an additional Philips screwdriver.