What is the Media Access Control (mac) Address of the G0/1 Interface??
Posted in mac | 2022-03-19
Which Command can be Used to Activate the G0 0 Interface?
To enable an interface, it must be activated using the no shutdown command. (This is similar to powering on the interface.) The interface must also be connected to another device (a hub, a switch, or another router) for the physical layer to be active.
Which Command can be Used to Display the Status and Configuration Details of the Fast Ethernet Interface 0 1 on Switch S1?
Use the show interfaces command to check the interface status.
What does Fastethernet0 0 Mean?
FastEthernet/0 is up, line protocol is up : this means that the interface is physically up and that the protocol is operational. When you use Ethernet , the protocol is normally up unless you configured portsecurity or BPDU guard.
Which One of the Following will Configure a Default Gateway Address to Switch S1?
As shown in Table 23 and Figure 25, R1 is the default gateway for S1. The interface on R1 connected to the switch has IP address 172.17. 99.1. This address is the default gateway address for S1.